Configuring An Access Port-Based Vlan - H3C S5500-SI Series Operation Manual

Operation Manual – VLAN
H3C S5500-SI Series Ethernet Switches
Table 1-3 Incoming and outgoing packets
Port type
Access
port
Trunk port
Hybrid
port

1.4.2 Configuring an Access Port-Based VLAN

You can configure an access port-based VLAN in two ways: configure it in VLAN view,
or configure it in Ethernet port view/port group view.
Incoming packet
If no tag is
If a tag is carried in
carried in the
packet
Encapsulate
the default
VLAN tag to the
packet
1-5
the packet
Receive the packet
when the VLAN ID
(recorded in the
tag) is the same
with the default
VLAN ID.
Drop the packet
when the VLAN ID
is different with the
default VLAN ID.
Receive the packet
when the VLAN ID
(recorded in the
tag) is the same
with the default
VLAN ID.
Receive the packet
when the VLAN ID
is different with the
default VLAN ID
but is allowed on
the port.
Drop the packet
when the VLAN ID
is different with the
default ID and is
not allowed on the
port.
Chapter 1 VLAN Configuration
Outgoing packet
Remove the tag and send
the packet directly for the
VLAN ID is just the default
VLAN ID.
When the VLAN ID is
the same with the
default VLAN
remove the tag of the
packet first and then
send the packet.
When the VLAN ID is
different with
default VLAN ID but is
allowed on the port,
keep the original tag
and send the packet.
When the VLAN ID is
allowed on the port, send
the packet. You
configure whether or not
to carry tags in
outgoing packets of a
VLAN (including default
VLAN) through the port
hybrid vlan command.
ID,
the
can
the