FUTABA 9 CHP SUPER Instruction Manual page 61

• Dial as master: To directly effect one servo's position by moving a dial, set the master as the desired dial.
(Ex: create a second throttle trim on left slider.)
MASTER SLAVE
VR(D) THRO
• Slave: the controlled channel. The channel that is moved automatically in response to the movement of the master
channel. The second channel in a mix's name (ie aileron-to-rudder).
• Link: link this programmable mix with other mixes.
Ex: PMIX FLAP-ELEVATOR mixing to correct for ballooning when flaps are lowered, but model has a V-tail. Without
LINK, this mix only moves CH2 elevator when flap is commanded, resulting in a dangerous combination of yaw and
roll. With LINK ON, mixing is applied to both CH2 and CH4.
MASTER SLAVE
FLAP ELEV
• Trim: master's trim affects slave. Not displayed if master is not CH 1-4, because 5-9 have no trim. Ex: two rudder
servos. With TRIM OFF, rudder trim would bind the two servos. TRIM ON resolves this.
• On/off choices:
• S
: Any of the positions of any of the 8 switches may be used to activate a mix. Up&Cntr, Cntr&Dn options
WITCH
allow the mix to be ON in 2 of the 3 positions of a 3-position S
• NULL: No S
can turn this mix OFF. This mix is active at all times.
WITCH
• STk-THR: Turned on/off by
doors) mix to open gear doors at idle, which is only active if throttle is below half.
MASTER SLAVE
OFST AUX2
• Rate: the percentage of the slave's range it will move upon maximum input from the master channel. Ex: RUDDER-
AILERON mix, 50%. Ail range=1". When rudder is moved full right, ailerons move ½".
MASTER SLAVE
RUDD AILE
• Offset: Offsets the slave's center relative to the master. Ex: Smoke valve opens wider per throttle servo position when
smoke S is ON. Smoke servo's neutral is moved down from T
WITCH
MASTER SLAVE
THRO AUX2
LINK TRIM SWITCH
OFF N/A ANY
LINK TRIM SWITCH
ON OFF ANY
movement. Trigger point/direction are selectable. Ex: OFST-to-(gear
THROTTLE STICK
LINK TRIM SWITCH
OFF NO STk-THR
LINK TRIM SWITCH
ANY
OFF OFF
LINK TRIM SWITCH
OFF OFF E
POSITION
NULL
POSITION
NULL
.
WITCH
POSITION
Stick at ½,
for 1 sec.
POSITION
NULL
S
HROTTLE TICK
POSITION
DOWN
6
RATE OFFSET
5% 0
RATE OFFSET
5% 0
RATE OFFSET
100% 0
RATE OFFSET
50% 0
center to the bottom.
RATE OFFSET
100% 100%