FUTABA 9 CHP SUPER Instruction Manual page 53

GOAL of EXAMPLE:
Activate SNAP-ROLL. Adjust elevator
travel to 55%, rudder travel to 120%in
the right/up snap. Activate SAFE-MOD
so snaps can not be performed when
gear is down.
Adjust rudder travel in the left/down
snap to 105%.
(Note: using negative percents can
change any of the 4 snapsí directions.
For example, change snap 1 to
ìdownî by changing the elevator
percent to -100%.)
Where next?
STEPS:
Open the SNAP-ROLL function.
Activate the function.
Adjust the travels as needed. (Ex:
elevator to 55%, rudder to 120%.)
Optional: Activate SAFE-MOD . [Ex: ON
when S E (9CA) or G (9CH) is
WITCH
down, meaning snap function is
deactivated when that switch is in the
down position.]
Optional: Assign switches to up/down and
left/right. (Ex: Change to the left/down
snap and adjust rudder to 105%.)
Close menu.
Set up programmable mixes: see p. 54.
View additional setups on the internet:
53
INPUTS:
for 1 second.
(If basic,
to SNAP-ROLL .
to OFF or ON.
to 55%.
to 120%.
E or G up.
snap switch.
Notice mix reading is still OFF.
E or G down.
Notice MIX reading changes to ON.
to A.
to B.
A down B down.
Repeat steps above to set percentages.
www.futaba-rc.com\faq\faq-9c.html.
again.)
ON.
to