FUTABA 9 CHP SUPER Instruction Manual page 29

9 channel radio control system
Hide thumbs Also See for 9 CHP SUPER:
Table of Contents

Advertisement

MODEL TYPE: sets the type of programming used for this model.
The 9C super has 12 model memories, which can each support:
one powered aircraft (ACRO) memory type (with multiple wing and tail configurations. See twin aileron servos, twin
elevator servos, ELEVON, and V-TAIL for further information.);
two glider wing types (again with multiple tail configurations). See Glider MODEL TYPE for details, p. 70;
six helicopter swashplate types, including CCPM. See Helicopter MODEL TYPE for details, p. 82.
Before doing anything else to set up your aircraft, first you must decide which MODEL T YPE best fits this particular aircraft.
(Each model memory may be set to a different model type.) If your transmitter is a 9CA super, the default is ACRO. If it is
a 9CH super, the default is HELI(SW1).
ACRO is the best choice for most powered airplanes, but in some circumstances, GLID2FLAP may be a better choice. ACRO
is usually a better choice because of functions it offers that the GLID types do not:
ACRO adds:
SNAP-ROLL
AILEVATOR (twin elevator servo support)
For fuel-powered airplanes: IDLE-DOWN, THR-CUT, THROTTLE-NEEDLE mixing and THROTTLE DELAY programming.
But ACRO lacks:
START and SPEED OFFSETS
4 seperate conditions for optional setups (GLID2FL-C)
If you are using a glider or heli MODELTYPE , please go to that chapter now to select the proper model type and support
your model setup. Note that changing MODEL TYPE resets all data for the model memory, including its name.
GOAL of EXAMPLE:
Select the proper MODEL TYPE for your
model. Ex: ACRO.
[NOTE: This is one of several functions
that requires confirmation to make a
change. Only critical changes require
additional keystrokes to accept
the change.]
STEPS:
Open the BASIC menu, then open the
PARAMETER submenu.
Go to MODEL TYPE.
Select proper MODEL TYPE.
Ex: ACRO.
Confirm the change. Close PARAMETER.
29
INPUTS:
Turn on the transmitter.
for 1 second.
(If
ADVANCE,
then
to highlight PARAMETER.
to choose PARAMETER.
to TYPE.
to ACROBATIC.
sure? displays.
to confirm.
to return to BASIC menu.
again.)
for 1 second.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

9cp super9caf super9cap super9chf super

Table of Contents