FUTABA 9 CHP SUPER Instruction Manual page 26

MODEL COPY: copies the current model data into another model memory (in the transmitter or the optional DP-16K
CAMPac). The name of the model memory you are copying into is displayed for clarity.
Data cannot be converted from 8U or 9Z memory types. If a CAMPac is installed into the 9C super that has data on
it from another radio type, it will have to be re-initialized which deletes all data.
Examples:
•
Start a new model that is similar to one you have already programmed.
•
Copy the current model data into another model memory as a backup or before experimenting with new settings.
•
Store your model data to an optional CAMPac prior to sending your radio for service.
•
Edit a copy of your model's data to fly the model in different conditions (ie. Helicopter using heavier night blades; glider
in extreme wind; airplane model at extreme altitudes).
•
Store your model data to an optional CAMPac to use or copy the settings into a friend's 9C super (A or H) transmitter
so he can fly your model or use it as a starting point for setting up a similar model.
GOAL of EXAMPLE:
Copy model 3 into model 5.
NOTE: This is one of several
functions for which the radio requires
confirmation to make a change.
Where next?
*Radio emits a repeating "beep" and shows progress on screen as the model memory is being copied. Note that if the power switch is turned off prior
to completion, the data will not be copied.
Notes:
•
Any data in the model copied to will be written over and lost, including name, type and
modulation. It cannot be recovered.
•
To copy from one 9C super to another, use an optional CAMPac. (Note: The model
may be flown directly off the CAMPac's memory, not requiring re-copying into
the 2nd transmitter. For more information on CAMPacs, please see p. 10.)
•
With the trainer FUNC mode it is not necessary to have the student radio contain the
setup of the aircraft. See TRAINER, p. 40.
STEPS:
Open the BASIC menu, then open
MODEL submenu.
Confirm you are currently using the
proper model memory. (Ex: 3)
Go to MODEL COPY and choose the
model to copy into. (Ex: 5)
Confirm your change.
Close.
SELECT the copy you just made: see p. 25.
Rename it (it is currently named exactly the same as the model copied): see p. 27.
Turn off the transmitter and remove the CAMPac for safekeeping or insertion
into another radio to fly.
INPUTS:
If SELECT does not indicate 3,
use MODEL SELECT, p. 25.
sure? displays.
26
for 1 second.
(If
ADVANCE,
to MODEL.
to 5.
for 1 second.
*
again.)