Elev-Flap - FUTABA 9 CHP SUPER Instruction Manual

ELEV-FLAP mixing (ACRO/GLID):
(ACRO)
(GLID)
Adjustability:
•Rate: -100% (full up flap) to +100 (full down flap), with a default of +50% (one-half of the flap range is achieved
when the E
S
LEVATOR TICK
•Switch: fully assignable. IF you set it to NULL, the mix does not work.
•Range (GLID): The range that mixing does not work near neutral of an elevator stick can be set up.
Hold the stick to the desired point (upper or lower side) , then press DIAL and hold one second to set the range.
GOAL of EXAMPLE:
Activate ELEV-FLAP mixing. Adjust
flap travel to 0% flaps with negative
elevator (push) and 45% flaps with
positive elevator.
Where next?
ELEV-FLAP mixing is the first pre-programmed mix weíll cover. This mix makes the
flaps drop or rise whenever the E
to make tighter pylon turns or squarer corners in maneuvers. In most cases, the flaps
droop (are lowered) when up elevator is commanded.
is pulled to provide full up elevator.)
STEPS:
Open the ELEV-FLAP function.
Activate the function.
Adjust the travels as needed. (Ex: 0%,
to 45%.)
Close menu.
Adjust flaperons' flap travel available (FLAPERON): see p. 45.
Set up AIRBRAKE (crow/butterfly): see p. 56.
Set up programmable mixes (ex: FLAP-ELEVATOR): see p. 60.
View additional setups on the internet:
S is moved. It is most commonly used
LEVATOR TICK
INPUTS:
www.futaba-rc.com\faq\faq-9c.html.
55
for 1 second.
(If basic,
again.)
to ELEV-FLAP .
E S . to 0%.
LEVATOR TICK
. to 45%.
E S
LEVATOR TICK