FUTABA 9 CHP SUPER Instruction Manual page 69

GOAL of EXAMPLE:
Adjust travels as needed to match
model's recommended throws (usually
listed as high rates).
P. 32.
Set up dual/triple rates and exponential
(D/R,EXP)
P. 35.
(Note that in the middle of the left side
of the screen is the name of the channel
and the S position you are
WITCH
adjusting. Two or even three rates may
be set per channel by simply choosing
the desired S and programming
WITCH
percentages with the S
WITCH
its 2/3 positions.)
Move flap control from the VR(A) dial
to the left slider [VR(D)]. (AUX-CH)
p. 39.
Where next?
STEPS:
In the BASIC menu, choose END POINT.
Adjust the servos' end points.
(Ex: flap servo)
Close the function.
Choose D/R,EXP.
Choose the desired control, and set
the first (Ex: high) rate throws and
exponential.
in each of
Set the second (low) rate throws and
exponential.
Optional: change dual rate S
assignment. Ex: elevator to S
with 3 positions.
In the BASIC menu, open AUX-CH.
Choose CH6 (flap).
Change primary control to VR(D).
Change other channels as needed.
Return to the home screen.
(Other functions you may wish to set up for your model.)
TRAINER p. 40.
Multiple wing or tail servos. See wing types and tail types: p. 44, 49.
START and SPEED OFFSETS, BUTTERFLY (AIRBRAKE/crow), and other
programmable mixes p. 54.
Retractable Gear, Smoke systems, kill switches, and other auxiliary channel
setups: p. 39.
Adjusting SUB-TRIMs to match servo centers: p. 42.
INPUTS:
2 steps to END POINT.
to choose END POINT.
VR(A)
VR(A). Repeat as needed.
to D/R,EXP.
to choose D/R,EXP.
to choose CH>2 (elevator).
A to up position.
to D/R.
E
LEVATOR
E
LEVATOR
(Normally the same for both directions.)
to EXP.
E
LEVATOR
E
LEVATOR
to D/R.
Repeat above to set low rate.
WITCH
to SW.
G
WITCH
center position.
Repeat steps above to set 3rd rate.
to AUX-CH.
to CH6.
to VR(D).
Repeat as required.
to FLAP.
until travel as desired.
to CH>.
[Note screen reads ELEV (UP)]
S . to set.
TICK
. to set.
S
TICK
. to set.
S
TICK
S . to set.
TICK
A to down position.
to G. G to
to choose AUX-CH.