FUTABA 9 CHP SUPER Instruction Manual page 73

Launch (Start) Offset (START OFS) (GLID1FLAP/GLID2FLAP only): The Start function is used to offset the aileron,
•
elevator, and flap servos to the position that provides maximum lift during launch. Normally the ailerons and flaps
are drooped about 20-30, with the flaps drooped slightly more to prevent tip-stalling on tow. The elevator can also
be offset in order to trim out any pitch changes caused by the flap and aileron presets.
Adjustability:
Switch: This function is activated by flipping S
•
Mix switch is selectable (3-position type switch only) in
the OFSET-SW item. (SW/MODE)
• Digital trim operation mode: Operation mode is selectable.
NORM: Normal digital trim operation
MIX: START OFS mixing rate trim operation while mixing is on.
Separate adjustments for each aileron and flap servo (two flap settings for GLID2FLAP) and for elevator.
•
RANGE for each adjustment is -100 to +100.
•
• Optional assignable dial (VR) to adjust all 4 wing servos in unison, 1% at a time, across all 4 servos in flight.
*During Launch Offset operation, the aileron and elevator travels are displayed on each trim display in the Startup
screen.
GOAL of EXAMPLE:
Set up a START OFS to gain maximum
possible lift on launch.
Each Aileron: 50%.
Each Flap: 100%.
Elevator: -5% to compensate.
Where next?
WITCH
STEPS:
Open START OFS function.
Activate the function.
Set the rates. (Ex: AIL1 and 2, 50%,
FLAP1 and 2, 100%, ELEV-5%.)
Optional: set a knob to adjust travel
of all 4 wing servos in flight.
Close the function.
SPEED OFS mixing. See p. 74.
BUTTERFLY. See p. 56.
Create a programmable mix to meet your model' s setups: see p. 60.
View additional model setups on the internet: www.futaba-rc.com\faq\faq-9c.html.
73
G (9CA) to the back position.
INPUTS:
for 1 second.
to 2nd page.
Flip switch G toward you.
to +50%.
to +50%.
Repeat for ELEV, FLP1 and 2, AIL2.
to desired knob.
(If BASIC menu ,
again.)
to START OFS.
to OFF.
to AIL1.
to AIL2.
to ELEV.