Basic Operation; Battery Charging - FUTABA 12Z Series Instruction Manual

BASIC OPERATION

Battery Charging

Before charging batteries, read the "Cautions for handling battery and battery charger" in the section
"Lithium-Ion Battery Safety and Handling Instructions".
How to charge the Lithium Ion battery
LT2F2200 for the transmitter
Danger
The Lithium-Ion battery LT2F2200 is only for
your T12Z. Do not use this battery for other
equipment.
Be sure to use the battery charger LBC-1D5 to
charge the battery.
To charge the battery while installed in the
transmitter, use the optional battery charger
CR-2500 for 12V.
[Method of charging battery]
1. Connect the power cable to the charger.
2. Connect the power cable of the charger to
the wall socket (AC outlet).
* The power lamp turns on.
3. Mount the battery and then slide the battery
hear a locking sound.
*The charge-lamp turns on and charging starts.
4. When the charge-lamp turns off, charging
has been completed.
*Be sure to remove the power cable from the wall socket
after using a battery charger.
*It takes about two and a half hours for charging the battery
pack that has been used fully. However, the charging time
may vary depending on the surrounding air temperature and
the condition of the battery pack.
*The charge LED blinks (error) if the battery is improperly
mounted or the battery itself is a defective product. In this
case, remount the battery or use another battery.
*If you mount a charged battery, the charge lamp will turn on
for several seconds, but it will turn off later.
22 <Basic Operation>
How to charge the Ni-Cd battery NR4F1500 for
the receiver
Use the battery charger FBC-32A that is included
in the set.
[Method of charging battery]
1. Connect the power cable of the charger to
to AC Outlet
the wall socket (AC outlet).
2. Connect the connector to the NiCd battery.
3. Remove the battery after 15 hours.
*Battery charging will not automatically stop. Remove the
battery from the charger and remove the charger from the
wall socket.
*It is recommended to reactivate the battery by cycling
several times if the battery has not been used for a long
period.
of the battery if you have used the battery only for a short
period or if you repeat charging while the battery is not fully
discharged. It is recommended to discharge the battery to the
recommended level after your usage. It is also recommended
to charge the battery just before your usage.
AC Outlet