FUTABA 12Z Series Instruction Manual page 42

*For this curve, [Linear] curve type can be used and the entire
curve can be lowered with the [Offset] function.
pitch interaction
swash plate in the aileron (roll) direction and
elevator (cyclic pitch) corresponding to each
operation of each condition.
RPM loss caused by swash operation at aileron
or elevator operation can be corrected with the
clockwise and counterclockwise torque is applied
when pirouetting can also be corrected.
10. Gyro sensitivity and mode switching
The gyro sensitivity and mode switching
Menu, and can be set for each condition.
42 <Model Basic Setting Procedure>
11. Throttle cut setting
º
Throttle cut provides an easy way to stop the
at idle. The action is not functional at high throttle
to avoid accidental dead sticks. The switch's
location and direction must be chosen, as it defaults
*With throttle stick at idle, adjust the cut position
until the engine consistently shuts off, but throttle
linkage is not binding. When finished, push the