FUTABA 12Z Series Instruction Manual page 72

AFR function is used to adjust the throw and
operation curve of the stick, lever, and switch
functions (CH1 to CH12, and V1 to V4) for each
flight condition. This is normally used after End
Point (ATV) has defined the maximum throw
settings). When mixing is applied from one channel
to another channel, both channels can be adjusted
at the same time by adjusting the operation rate
through the AFR function.
setup screen shown below by pushing the enter
button.
[Return Key]
(For more information, see the description at the back
of this manual.)
72 <Model Menu (Common Functions)>
which can be switched by switch, etc. can also be added. [All model types]
(Currently selected condition name)
(For a description of the setting method, see the
description at the back of this manual.)
(Number of D/R curves set at the currently
selected condition)
Function selection method
left or right, push the enter button.
*The setting mode (group [GROUP]/single [SNGL] mode) can be switched (For more
information, see the description at the back of this manual.)
spline) can be selected. A maximum 17
points curve can be used for the line and
The number of points can also be increased
and decreased and curves from complex
curves to simple curves can be used.
speed of each function when the function
is operated (including at flight condition
switching) can be adjusted. The function
operates smoothly at a constant speed
corresponding to the set speed.
[AFR/D/R]: Displays the currently
selected rate (AFR, D/R1~6).
PUSH
[GRP/SNG]: Group/single mode setting
display
(For a description of the setting
method, see the description at
the back of this manual.)
[Cursor Lever]
[Data Input Dial]
[Enter Button]