FUTABA 12Z Series Instruction Manual page 38

4. Throttle cut setting
Throttle cut can be performed with one touch by a
switch without changing the throttle trim position.
Set throttle cut with the Throttle Cut function of
the Linkage Menu. After activating the throttle cut
function and selecting the switch, adjust the throttle
position so that the carburetor becomes fully closed.
For safety, the throttle cut function operates the
throttle stick in the 1/3 or less (slow side) position.
5. Idle down setting
The idling speed can be lowered with one touch by
a switch without changing the throttle trim position.
Perform this setting with the Idle Down function of the
Linkage Menu. After activating the Idle Down function
and selecting the switch, adjust the idle down speed.
For safety, the idle down function acts only when the
throttle stick is slow side.
*While the Throttle Cut function is in operation, the Idle
Down function does not work.
6. AFR (D/R)
AFR function is used to adjust the throw and
operation curve of the stick, lever, and switch functions
This is normally used after End Point (ATV) has
7. Airbrake
This function is used when an air brake is necessary
when taking off or diving, etc.
The preset elevators and flaps (camber flap, brake
38 <Model Basic Setting Procedure>
servos can be adjusted as needed. Also the speed of the
side/OUT side) A delay can be set for each condition,
and a Cut switch which will turn OFF the delay can be
chosen. Trim amounts can be fine-tuned by setting a
VR. You can also set the Auto Mode, which will link
Airbrake to a stick, switch, or dial. A separate stick
per model. You can assign all switches including sticks,
to these functions in order to avoid sudden changes.
when you set more than one condition. In addition, you
can copy conditions and/or change names of conditions.
The Condition Select function automatically allocates
the Condition 1 for each model type. Condition 1 is
the only one active when a new model type is defined.
This condition is always on, and remains on until other
conditions are activated by switches.
The Condition Delay can be programmed for each
channel. The Condition Delay is used to change the
servo throw smoothly when switching conditions.
*When a new condition is added, "Condition1" data is
automatically copied.
*Select the condition switch and set the new condition data in
was selected in advance, the same data will be input at all the
condition you want to change.
9. When tailless wing model selected
Tailless wing elevator operation uses elevator to camber