FUTABA 12Z Series Instruction Manual page 125

Switch selection method
lever, or VR are used as a switch) setting method is common to all functions.
Switch selection
(Switch selection screen example)
When switch was selected
When switch was selected, ON/OFF position
setting is also performed.
1. Use the cursor lever to move the cursor
(reverse-video) to the switch you want
to select and push the enter button. The
switch is selected and the ON/OFF position
setup screen shown below is displayed.
*The ON/OFF setting state of each position is displayed.
setting, use the cursor lever to move the
cursor (reverse-video) and switch the ON/
Off display by turning the data input dial
to the left or right.
*ON/OFF display blinks.
OFF setting is changed. (Operate another
key to stop the change.)
4. Return to the original screen by return key.
Edit key
[Cursor Lever]
[Data Input Dial]
PUSH
When stick, trim lever, or knob selected
When a stick, trim lever, or knob is used as a
switch, four operation modes can be selected by
the following mode and type combination:
Mode: [LINEAR](Linear)/[SYMMET](symmetrical)
1. Use the cursor lever to move the cursor
(reverse-video) to the stick, trim lever, or
knob you want to select and push the
enter button. The stick, trim lever, or knob
is selected as a switch and the ON/OFF
position setup screen shown below is
displayed.
type, move the cursor to [MODE] or [TYPE]
and switch the display to the mode or
type you want to change by turning the
data input dial to the left or right and then
make the change by pushing the enter
button.
*
[Enter Button]
<Data> 125