FUTABA 12Z Series Instruction Manual page 111

Curve setting examples
The curves shown below were created by using
the Line mode and inputting the data of the 5 points
0% (low side), 25%, 50% (center), 75%, 100%
(high) side at each condition. They were created by
reducing the number points of the line to 5. When
Normal Curve
Throttle Hover trim
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
[Return Key]
The Throttle Hover function trims the throttle
near the hovering point. Normally, use it with
hovering conditions. Changes in rotor speed
accompanying changes in the temperature,
humidity, and other flight conditions can be
trimmed. Adjust the throttle so that rotor rotation is
most stable. More delicate trimming is also possible
by using this function along with the Hover Pitch
function.
Setting method
can be selected.
CTRM mode:
NORM mode:
actually creating a curve, enter the data specified
per the aircraft (or the reference value).
*For a description of the curve creation method, see the
Idle-up 1 Curve Idle-up 2 Curve
<Functions of Model Menu (Helicopter Functions)>
description at the back of this manual.
PUSH
changing the curve.
the center.
direction can be set.
[Cursor Lever]
[Data Input Dial]
[Enter Button]
111