FUTABA 12Z Series Instruction Manual page 77

This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture
control carburetor.
and call the setup screen shown below
by pushing the enter button.
[Return Key]
(For a description of the setting
method, see the description at
the back of this manual.)
(For more information,
see the description at the
back of this manual.)
setting
Setting method
*Before using this function, assign the [FUEL-MIX] function
to a vacant channel by linkage menu [FUNCTION] function.
*Perform the following settings after using the cursor lever to
move the cursor to the item you want to set.
is displayed.)
curve setting data becomes the mixing
master side data.
selected and its operating range can be set.
center by center trim operation. When
near the center.
fuel mixture control carburetor. [Airplane, helicopter]
*The needle channel is not assigned as a default.
(For a description of the acceleration function setting method,
(Currently selected condition name)
PUSH
active only near the center.
function is used when there are symptoms of
the mixture being too lean or too rich, which
would be generated by sudden operation of
see the description at the back of this manual.)
(throttle hold function (cut and idle positions),
throttle cut function, and idle down function
is possible. The needle side cut position
position.
<Model Menu (Common Functions)>
[Cursor Lever]
[Data Input Dial]
[Enter Button]
77