FUTABA 12Z Series Instruction Manual page 126

Operation modes
The operation modes when stick, trim lever, or
knob was selected are described below.
*When the enter button is pushed after the cursor was moved
to the [MODE] and [TYPE] items and the mode was
selected by data input dial, the operation mode is changed.
Linear hysteresis mode
This mode sets ON/OFF at the left or right
(up or down) with the set point as the reference.
Hysteresis (dead band) can be set between ON and
OFF. The ON and OFF positions can be reversed.
Linear box mode
This mode turns on the switch within a range of
positions can be reversed.
Symmetrical hysteresis mode
Operation is the same as the linear hysteresis
mode, but left and right (up and down) operations
are symmetrical about the neutral position. For
instance, when you want to switch DR1 with the
aileron stick, when the stick is moved to the left or
right, DR1 can be turned on at the same left and
right position.
126 <Data>
Symmetrical box mode
but left and right (up and down) operation is
symmetrical about the neutral position.
Shifting the ON/Off point
The ON/OFF and hysteresis (dead band)
boundary point can be shifted. ON/OFF at a
free position and the hysteresis width can be
changed.
[Setting method]
1. First, use the cursor lever to move the
cursor (reverse-video) to the [PNT:] item.
left, the ON side point can be set and
when the data input dial is turned to the
right, the OFF side point can be set.
3. Move the stick, trim lever, or knob to the
point you want to change and push the
enter button. The point is shifted.
A hysteresis range can be created by
the ON side and OFF side point setting
described above.