Advanced Setup Window - Cisco CIVS-IPC-2500W - Video Surveillance IP Camera Network User Manual

Setup Windows
Table 3-3
Option
Edit Region Settings /
Hide Region Settings
toggle button
Region Option

Advanced Setup Window

The Advanced Setup window provides options for configuring various network and protocol settings for
the IP camera.
To display the Advanced Setup window, access the configuration windows as described in the
"Performing the Initial Setup of the IP Camera" section on page
Setup.
If you change any options in the Advanced Setup window, you must click Save to save the changes. To
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the
window. You may need to scroll down to see them.
Table 3-4
Table 3-4
Option
CDP
Note
Enable CDP (Cisco
Discovery Protocol)
Cisco Video Surveillance System IP Camera User Guide
3-10
Wireless Setup Window Options (continued)
Description
Click the Edit Region Settings button to display the Region Option
drop-down list. Click the Hide Region Settings to hide this drop-down list.
Choose the region in which the IP camera operates. The region determines
which channels the wireless IP camera uses to communicate with an access
point.
Options are:
Americas—Causes the IP camera to communicate with an access point
•
on channels 1 through 11.
EMEA/Asia—Causes the IP camera to communicate with an access
•
point on channels 1 through 13.
Custom—Causes the IP camera to communicate with an access point on
•
the channels that you specify. Use this option to customize channel
communication settings for your area. When you choose this option, 13
channel check boxes appear. Check the check boxes that correspond to
the channels that you want.
describes the options in the Advanced Setup window.
Advanced Setup Window Options
Description
This feature is not currently supported if you use the IP camera with Cisco VSM.
Check this check box if CDP is enabled in your network and you want the IP
camera to send CDP discovery messages.
Chapter 3 Configuring and Managing the IP Camera
2-5, click Setup, then click Advanced
OL-14220-02