Cisco CIVS-IPC-2500W - Video Surveillance IP Camera Network User Manual page 11

Chapter 1 Overview
5
PoE LED (green)
6 Analog video output
7 Speaker output
8
Microphone input
9 GPIO ports
10 Power input
Figure 1-3
Figure 1-3
1 DC auto iris lens connector
2
Lockdown cable slot
OL-14220-02
Indicates information about PoE as follows:
•
•
BNC connector for video output (75 ohm).
Allows the connection of an optional external speaker through a
standard 3.5 mm mini phone jack.
Allows the connection of an optional external microphone (with
pre-amplifier) through a standard 3.5 mm mini phone jack.
Microphones that are designed for use with PCs usually are
compatible with this input jack.
Connecting an external microphone disables the internal
microphone on the IP camera.
General purpose input/output (GPIO) terminal block that includes
a 2-pin RS-485 port, 2 input ports (labeled DI1, DI2), 2 output
ports (labeled DO1, DO2), and 3 ground ports (labeled GND).
Provides for the connection of an optional 12 V, 1 amp DC power
adapter.
Caution
and the table that follows describe the items on the side of the IP camera.
Side of IP Camera
Connection for cable from DC auto iris lens
Connection for Kensington-compatible lockdown equipment
On—PoE connection is detected
Off—PoE connection is not detected
Use only the Cisco specified power supply adapter.
Cisco Video Surveillance System IP Camera User Guide
IP Camera Physical Details
1-5