Cisco CIVS-IPC-2500W - Video Surveillance IP Camera Network User Manual page 47

Chapter 3 Configuring and Managing the IP Camera
–
–
–
–
Note
By default, the video in a video file starts when an event starts and ends 5 seconds after the event ends.
You can designate that additional video be included before and after an event as described in the
Window" section on page
To display the Mail & FTP window, access the configuration windows as described in the
the Initial Setup of the IP Camera" section on page
If you change any options in the Mail & FTP window, you must click Save to save the changes. To
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the
window. You may need to scroll down to see them.
Table 3-14
These features are not currently supported if you use the IP camera with Cisco VSM.
Note
Table 3-14
Option
Primary SMTP Server
Primary SMTP
SMTP Mail Server
Authentication
Account Name
Password
POP Server Name
Secondary SMTP Server
Secondary SMTP
OL-14220-02
Event_name describes the event that caused the alert. For motion detection events, this field is
the name of the video field area in which motion was detected (for example, Window 2). For
input events, this field is input1 or input2, depending on which input port the event was detected.
yymmdd is the 2-digit year, month, and date on which the event occurred.
hhmmss is the, hours, minutes, and seconds at which the event occurred.
xxx is the format of the file (asf, mp4, or 3gp), as configured in the Video Format (MPSG-4)
field in the Event window.
A large video file may exceed the maximum file size for e-mail attachments that is configured
on your mail server.
3-28.
describes the options in the Mail & FTP window.
Mail & FTP Window Options
Description
Check this check box to cause e-mail messages to be sent to the primary
Simple Mail Transport Protocol (SMTP) server.
Enter the name or IP address of the primary SMTP server.
If you enter a name, you must configure the Primary DNS option as
described in the
If the primary SMTP server requires authentication to send e-mail, choose
the appropriate authentication type. The authentication type typically is the
same as that for the POP3 server that you use to receive e-mail.
If the primary SMTP server requires authentication, enter the account name
for the server.
If the primary SMTP server requires authentication, enter the account
password for the server.
Enter the name of the POP3 mail server that you use to receive e-mail.
Check this check box to cause e-mail messages to be sent to a secondary
(backup) SMTP server if the primary SMTP server is unavailable.
2-5, click Applications, then click Mail & FTP.
"Basic Setup Window" section on page
Cisco Video Surveillance System IP Camera User Guide
Applications Windows
"Event
"Performing
3-5.
3-25