Alarm I/O Ports Window - Cisco CIVS-IPC-2500W - Video Surveillance IP Camera Network User Manual

Chapter 3 Configuring and Managing the IP Camera
To display the SNMP window, access the configuration windows as described in the
Initial Setup of the IP Camera" section on page
If you change any options in the SNMP window, you must click Save to save the changes. To discard the
changes, click Cancel before clicking Save. These buttons appear at the bottom of the window. You may
need to scroll down to see them.
Table 3-17
These features are not currently supported if you use the IP camera with Cisco VSM.
Note
Table 3-17
Option
SNMP Enable
System Object ID
System Contact
SysLocation
Read Community String Enter the SNMP read community string, which identifies the valid read
Primary Trap Receiver
Secondary Trap
Receiver

Alarm I/O Ports Window

The Alarm I/O Ports window allows you to configure various options for the two input and two output
ports on the IP camera. A state change of an input ports triggers a camera to take configured actions.
Output ports send relays that can control external devices, such as alarms or door switches.
To display the Alarm I/O Ports window, access the configuration windows as described in the
"Performing the Initial Setup of the IP Camera" section on page
Ports.
If you change any options in the Alarm I/O Ports window, you must click Save to save the changes. To
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the
window. You may need to scroll down to see them.
Table 3-18
These features are not currently supported if you use the IP camera with Cisco VSM.
Note
OL-14220-02
describes the options in the SNMP window.
SNMP Window Options
Description
Check this check box to enable SNMP.
Display only. Displays the system object ID, which identifies system
properties of the IP camera.
Enter system contact information for the system administrator. For example,
enter the e-mail address of the system administrator.
Enter system location information, which identifies the physical location of
the IP camera.
community.
The default value is public (all lower case).
Enter the IP address of primary trap receiver of the SNMP manager.
Enter the IP address of secondary trap receiver of the SNMP manager.
describes the options in the Alarm I/O Ports window.
2-5, click Applications, then click SNMP.
2-5, click Applications, then click I/O
Cisco Video Surveillance System IP Camera User Guide
Applications Windows
"Performing the
3-31