Configuring Usb Settings; Configuring Trace Settings - Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Table 6-3 Profile Settings (continued)
Item
Antenna Selection for
802.11B
802.11G Power Settings
802.11A Power Settings
Note If you uncheck all channels in the 802.11 G Power Settings or 802.11 A Power Settings, the phone will
not be able to access the WLAN.

Configuring USB Settings

You can change the IP address of the USB port on your phone by choosing one of the following options
in the DHCP Enabled field:
•
•
Note See also

Configuring Trace Settings

You can configure trace settings to determine how the phone creates and saves trace files.
describes the trace settings.
Table 6-4
Item
Number of Files
Enable Remote Syslog
Remote IP Address
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
OL-15985-01
Description
Vertical
•
Horizontal
•
Diversity
•
Enabled—Identifies enabled channels in WLAN to improve
scanning for the phone
Max Tx Power—Sets the maximum transmit power for the
phone
Enabled—Identifies enabled channels in WLAN to improve
scanning for the phone
Max Tx Power—Sets the maximum transmit power for the
phone
Yes—Obtains an IP address automatically.
No—You can specify the IP address and subnet mask on this page.
Configuring USB Settings, page
Trace Settings
4-28.
Description
Choose the number of trace files that the phone saves, from 2-10
files.
Set up a remote server to store trace logs. If enabled, enter remote
address and remote port.
Enter remote IP address if Enable Remote Syslog is enabled.
Configuring USB Settings
For More Information, See...
Table 6-4
6-9