Before You Begin - Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual

Configuring the Phone Using the Wavelink
Avalanche Server
This chapter describes the Wavelink Avalanche Management Console and how to use it to configure the
Cisco Unified Wireless IP Phone 7921G. The Cisco Unified Wireless IP Phone 7921G Phone
Configuration Utility can be installed on the Wavelink Avalanche Management Console and used to
configure a single phone or multiple phones with common settings.
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
There is no support for Traffic Stream Rate Set (TSRS) or Cisco Compatible Extensions (CCX) V4.
Note

Before You Begin

Before you can use the Wavelink Avalanche Management Console to configure phones, ensure that you
have the necessary components and follow the best practices during your setup.
The following components are required for configuring the phone using the Wavelink Avalanche
Management Console:
•
•
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
OL-15985-01
Before You Begin, page 6-1
Best Practices, page 6-2
Assigning the Wavelink Avalanche Server, page 6-2
Setting Up and Using the Phone Configuration Utility, page 6-3
Installing the Cisco Unified Wireless IP Phone 7921G Configuration Utility, page 6-5
Configuring USB Settings, page 6-9
Configuring Trace Settings, page 6-9
Configuring Wavelink Avalanche Server Settings, page 6-10
Updating the Phone, page 6-11
Wavelink Avalanche software
Avalanche Manager Agent
-
Avalanche Management Console
-
Cisco Unified Wireless IP Phone 7921G current firmware release
6
C H A P T E R
6-1