Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual page 82

Configuring Network Profiles
Table 4-2
Item
IP Network Configuration
Obtain IP address and
DNS servers
automatically
Use the following IP
address and DNS
servers
TFTP
Obtain TFTP servers
automatically
Use the following
TFTP servers
Network Profile Advanced Settings
TSPEC Settings
Minimum PHY Rate
Surplus Bandwidth
Antenna Settings
Antenna Selection for
802.11A
Antenna Selection for
802.11G
802.11G Power Settings
Channel Enabled
Max Tx Power
Check All/Clear
All/Check
Non-overlap
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
4-12
Network Profile Settings Items (continued)
Description
Enables DHCP
Disables DHCP and uses these static settings:
• IP Address
Subnet Mask
•
• Default Router
Primary DNS
•
Secondary DNS
•
Domain Name
•
Determines whether DHCP assigns the TFTP
server
Assigns static TFTP server IP addresses for:
TFTP Server 1
•
TFTP Server 2
•
Minimum data rate that outbound traffic uses
Note Cisco APs support only PHY rates of
6, 11, 12, or 24.
Excess bandwidth beyond application
requirements
• Vertical
• Horizontal
• Diversity
• Vertical
• Horizontal
Diversity
•
Identifies enabled channels in WLAN to
improve scanning for the phone
Sets the maximum transmit power for the
phone
Three buttons that check all channels and Tx
power levers, or clear all. The non-overlap
button disables overlap.
Chapter 4 Using the Cisco Unified Wireless IP Phone 7921G Web Pages
For More Information, See...
Configuring IP Network
Settings, page 4-25
Configuring the Alternate
TFTP Server, page 4-26
Configuring Advanced
Network Profile Settings,
page 4-27
OL-15985-01