Viewing The Site Survey Report On The Web - Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 4 Using the Cisco Unified Wireless IP Phone 7921G Web Pages
Caution When setting the Administration Password in the Product Specific Configuration section in Cisco
Unified Communications Manager 5.0 Administration, you must enable TFTP encryption. Otherwise,
the password appears in readable text in the phone configuration file and can be viewed from any host
that has access to TFTP server.
Related Topics
•
•
•
•

Viewing the Site Survey Report on the Web

Before the Site Survey Report is generated for viewing from the phone web page, you must first run the
Site Survey utility from the phone. For more information, see
To view the report, go to the phone web page and choose Site Survey from the left pane. An HTML
report in the form of a neighbor table of APs is displayed.
You can also run the Neighbor List utility from the phone to display a list of current APs on the phone.
Note
However, this utility will not generate the Site Survey Report that you can access from the phone web
page. See also
The neighbor table provides a matrix of APs observed during the site survey. Depending on the extent
of the survey, not all observed APs will be considered a best AP or an immediate neighbor.
The Site Survey Report stores information about each AP until it reaches a limit of 256 APs. For each
AP, up to ten neighbors are tracked.
Table 4-8
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
OL-15985-01
Using System Settings, page 4-36
Viewing Trace Logs, page 4-36
Upgrading Phone Firmware, page 4-40
Backup Settings for Phone Configuration, page 4-37
Neighbor List Utility, page
shows the information shown in the site survey report.
Site Survey Utility, page
2-21.
Using System Settings
2-22.
4-41