Configuration Tip For Cisco Aironet Aps; Site Survey Verification; Site Survey Verification Tasks - Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual

For cisco unified communications manager 7.0
Hide thumbs Also See for 7921G - Unified Wireless IP Phone VoIP:
Table of Contents

Advertisement

Site Survey Verification

Configuration Tip for Cisco Aironet APs

If you are using EAP-FAST, you must increase the EAP request (802.1x) timeout to at least 20 seconds
to ensure that the phone gets the PAC credentials successfully.
To change the request timeout on the controller, follow these steps:
Procedure
Use SSH or Telnet to access the Cisco Unified wireless LAN controller.
Step 1
Enter
Step 2
Step 3
Enter
Step 4
Enter
Site Survey Verification
Before the initial deployment of wireless phones in the WLAN, it is recommended that a site survey is
performed to verify that the APs are providing adequate coverage and that wireless phones can roam
from one AP to another with no audio problems. After the initial deployment, it is a good practice to
perform site surveys at regular intervals to ensure continued coverage and roaming.
From the Cisco Unified Wireless IP Phone 7921G, you can use the Neighbor List utility or Site Survey
utility from the Settings > Status menu.
The Neighbor List utility provides information about the current AP and the closest neighbors tracked
by the phone. For more information see
The Site Survey utility produces a report, written as a temporary HTML file, upon termination of the
survey. This Site Survey Report is accessible from the phone web page for viewing or forwarding to
Cisco TAC for troubleshooting purposes. For more information, see
You should use the wireless IP phone and the Aironet Client Utility (ACU) to verify that the signal range
and transmission power provide adequate coverage for roaming phones.
Use the following topics for information about performing the site survey:

Site Survey Verification Tasks

Perform these tasks to verify wireless voice network operation. Check that the wireless IP phones:
1.
2.
3.
4.
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
2-20
config advanced eap request-timeout 20
.
save config
to confirm.
y
Site Survey Verification Tasks, page 2-20
Neighbor List Utility, page 2-21
Site Survey Utility, page 2-22
Associate with all APs in the WLAN.
Authenticate with all APs in the WLAN.
Register with Cisco Unified Communications Manager.
Can make stationary phone calls with good quality audio.
Chapter 2
.
Neighbor List Utility, page
Overview of the VoIP Wireless Network
2-21.
Site Survey Utility, page
OL-15985-01
2-22.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-7921g-a-k9

Table of Contents