Set Up Usb Settings On Pc - Cisco 7925G Administration Manual

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Caution
Step 7 Click Save to make the change.
Related Topics
Access Phone Configuration Web Page, on page 71
Network Profile Settings, on page 75
Set Up Wireless Settings in Network Profile, on page 80
Wireless LAN Security, on page 80
Wireless Security Credentials, on page 83
Pre-Shared Key Setup, on page 83
IP Network Settings, on page 92
Set Up Alternate TFTP Server, on page 93

Set Up USB Settings on PC

To use the USB cable from your PC to a phone, you must configure the USB settings to work with the USB
port on the PC. The phone has a default USB IP address of 192.168.1.100. You can change the USB port
configuration on the phone in these ways:
• To obtain the IP address automatically, by getting an IP address from the PC that has DHCP set up.
• To use the IP address and subnet mask assigned in this area.
To display the USB Settings area, access the web page for the phone as described in
on page
To change the USB port settings for the phone, follow these steps:
Procedure
Step 1 On the phone web page, choose the USB Settings hyperlink.
Step 2 Choose one of the following options:
• Obtain IP address automatically
• Use the following IP address
Step 3 To change the static IP address, in the IP Address field, enter a new IP address that is not assigned on the
subnet.
Step 4 To change the subnet for the new IP address, in the Subnet Mask field, enter the appropriate subnet mask.
Step 5 Click Save to make the change.
You must check at least one channel after using Clear All, to enable the phone to access the
WLAN.
69, and then click the USB Settings hyperlink.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
Set Up USB Settings on PC
Access Phone Web Page,
95