Enable Mobile Vpn With Ssl For A Group - Watchguard Firebox X15 User Manual

Enable Mobile VPN with SSL for a group

When you enable Mobile VPN with SSL on your Edge, you must make sure to enable access for each remote
user or group who uses SSL to connect to the Edge. If you use extended authentication, you must configure
the group name to match exactly the name of the group on your authentication server. The Firebox supports
extended authentication to an LDAP/Active Director or a RADIUS authentication server.
1. To connect to the System Status page, type
of the Firebox X Edge trusted interface.
The default URL is https://192.168.111.1
2. From the navigation bar, select Firebox Users > New Groups.
The New Group page appears.
3. In the Account name text box, type the name for the group. If you use extended authentication to an
LDAP, Active Directory, or RADIUS authentication server, make sure you type the name of the group
exactly the same as it was entered on the authentication server.
4. In the Description field, type a description for the user. This is for your information only. A user does
not use this description during authentication.
5. In the Administrative Access drop-down list, set the level to which the members of this group can see
and change the Firebox X Edge configuration properties: None, Read-Only, or Full.
6. In the Session maximum timeout field, set the maximum length of time the computers in this group
can send traffic to the external network or through a Branch Office VPN tunnel. If this field is set to zero
(0) minutes, there is no session timeout and the user can stay connected for any length of time.
User Guide
in the browser address bar, and the IP address
https://
About Mobile VPN with SSL
291