Configure An Individual User Account - Watchguard Firebox X15 User Manual

User and Group Management
About user accounts
When you create a local user for the Firebox X Edge e-Series, you select the administrative access level for that
user. You select access control for the external network and the Branch Office VPN tunnel, and time limits on
this access. You also can enable Mobile VPN with PPTP, enable Mobile VPN with SSL, add a WebBlocker profile
to the user account, and configure the user's Mobile VPN with IPSec settings.
Three levels of Administrative Access are available for the Firebox X Edge:
None: This level allows users to connect to resources on the external network. A user who uses this
access level cannot see or change the Edge configuration pages.
Read-Only: Use this level for users who need to see Edge configuration properties and status. A user
who uses this access level cannot change the configuration file.
Full: Use this level for users who can see and change Edge configuration properties. You also can
activate options, disconnect active sessions, restart the Edge, and add or edit user accounts. A user who
uses this access level can change the password for all user accounts.

Configure an individual user account

1. To connect to the System Status page, type
of the Firebox X Edge trusted interface.
The default URL is: https://192.168.111.1
2. From the navigation bar, select Firebox Users.
The Firebox Users page appears.
3. Below Local User Accounts, click Add.
The New User page appears. It shows the Settings tab.
190
in the browser address bar, and the IP address
https://
Firebox X Edge e-Series