Set Access Control Options (Outgoing) - Watchguard Firebox X15 User Manual

Firewall Policies

Set access control options (outgoing)

1. From the Edit Policies page, select the Outgoing tab.
2. From the Outgoing Filter drop-down list, select the rule you want to apply. This rule affects only
outgoing traffic.
3. To specify which computers on your trusted and optional network can use this policy, in the From field,
select Any and click Remove. Select Host IP Address, Network IP Address, Host Range, or Alias from
the drop-down list. Then enter the IP address or range of IP addresses you want to allow and click Add.
You can add more than one address. If you select Alias, you can choose from Trusted Network,
Optional Network, Wireless Guest Network, or from groups of Mobile VPN users.
Type network IP addresses in slash notation. For more information, see About slash notation.
4. To limit which computers on the external network can connect to computers on the trusted or optional
networks with this policy, in the To field, select Any and click Remove. Select Host IP Address,
Network IP Address, or Host Range from the drop-down list. Then enter the IP address or range of IP
addresses you want to allow and click Add. You can add more than one address.
5. If your Firebox uses Edge Pro appliance software and you have configured a second external interface
for your Firebox set for multi-WAN round robin load balancing, you can apply policy-based routing to
the policy. Use the Policy-based routing interface drop-down list to select the external interface you
want to use for all traffic managed by this policy. For more information about policy-based routing, see
About policy-based
6. To have the Firebox save log messages for this policy to the log file, select the Log outgoing traffic
check box.
7. Click Submit.
120
routing.
Firebox X Edge e-Series