Watchguard Firebox X15 User Manual page 214

User and Group Management
Install the SSO agent service
Double-click
WG-Authentication-Gateway.exe
may need to type a local administrator password to run the installer on some operating systems. Follow the
instructions to install the software:
Setup - Authentication Gateway
Click Next to start the wizard.
Select Destination Location
Type or select a location to install the software, then click Next.
Select Start Menu Folder
Type or select a location in the Start Menu to add program shortcuts. If you do not want to add
program shortcuts to your Start Menu, select the Don't create a Start Menu folder check box. When
you are finished, click Next.
Domain User Login
Type the domain user name and password of a user with an active account on your current LDAP or
Active Directory domain. You must enter the user name in the form:
this does not include the .com or .net part of the domain name. For example, if your domain is
mywatchguard.com and you use the domain account ssoagent, enter the user name in this step as
mywatchguard\ssoagent
Ready to Install
Review your settings, then click Install to install the service on your computer.
Setup - Authentication Gateway
Click Finish to close the wizard. The WatchGuard Authentication Gateway service starts
automatically when the wizard completes, and starts each time the computer restarts.
202
. Click Next.
If the user account you specify does not have enough privileges, some users cannot use SSO and
must authenticate with the Firebox normally. We recommend you follow the instructions in the
previous section to create a user account for the SSO agent service.
to start the Authentication Gateway setup wizard. You
. Note that
domain\username
Firebox X Edge e-Series