Expobar ZIRCON MINI 1GR CONTROL Service Manual page 30

SERVICE PROGRAMMING
Reset parameters to factory default
Data reset
completed
Fig. 10
Accessing service programming
+
OFF hh:mm
Fig. 11
Language selection
Language
Language
Fig. 12
30
R
To reset the control panel settings to the factory default:
Switch off the machine at the power switch.
Press and hold down the 1 Short Espresso
Continuous Dispensing buttons
buttons until the message shown in g. 10 is displayed.
Turn the machine off and then on again. The machine will now be in stand-by mode.
- ok
ON STAND-BY (OFF)
Accessing these settings menus is only possible via the left-hand button panel (when
the machine is viewed from the front).
To access the settings menus:
Turn the machine OFF (stand-by) by pressing and holding down the Continuous
Dispensing button
Espressos button
Hold down the Continuous Dispensing button
shows the "Language" option, see g. 12).
When "Language" is displayed, select the desired language.
To change language:
Press the 1 Short Espresso button
languages and the 1 Long Espresso button
them.
Languages available: Spanish, English, French, Italian, German and Portuguese.
To accept the language selected and access the next menu, press the Continuous
Dispensing button .
then turn on the machine. Hold down the
Stand-by + Press >14 s → Service prog.
Next menu
whilst the machine is ON then pressing the 2 Short
(see g. 11).
(+) to cycle forward through the
ZIRCON
, 2 Short Espressos
for 15 seconds (until the display
(-) to cycle backward through
and