Humanscale efloat next Assembly Instructions Manual page 45

One-Touch / Constant-Touch
Follow the steps below to change between One-Touch and Constant - Touch. One-Touch requires
only a single touch of the "1, 2 or 3" button to move the worksurface to a preset memory
location. One-Touch is the default setting. Constant-Touch requires a continuous touch of the
"1, 2, or 3, " but ton to move the worksurface to a preset memory location.
1. Press the DOWN button, moving the desk to its lowest position, then release.
2. Hold the DOWN button again, until the LED display reads "
3. Hold the "1" button (about 5 seconds) to switch settings. Repeat until desired setting is
displayed.
10.1 = One-Touch
10.2 = Constant-Touch
4. Once the chosen setting is displayed, wait 5 seconds for the display to return to "
5. Hold the DOWN button while the desk clicks lower, slightly rises and stops.
Setting LED Retracted Height
Press and hold the DOWN button until the worksurface reaches its lowest position. Measure the
distance from the floor to the top surface of the desktop. If the number on the LED display does
NOT match your measurement, follow these steps:
1. Hold the DOWN button again, until the LED display reads "
2. Hold the "M" button (about 5 seconds) until the display starts flashing the height.
3. Use the UP/DOWN button to match your measurement.
4. Wait 5 seconds for the display to return to "
5. Hold the DOWN button while the desk clicks lower, slightly rises and stops.
Setting Upper and Lower Limits
This desk is designed to go to its minimum and maximum heights, allowing for the longest
possible range. If you prefer to change the settings to a more shorter range, follow these steps:
To Set the Upper-Limit Position:
1. Use the UP /DOWN buttons to move the base to the desired maximum-height position.
2. Press the "M" button.
3. Press the UP button. The LED display will flash "S -" .
4. Hold the "M" button (about 2 seconds) until the LED display changes to "999" . The
display will automatically return to the selected height. The new upper limit is now set.
".
".
".
".
45