Humanscale efloat next Assembly Instructions Manual page 21

3
Place your worksurface upside down on a protective surface. Lift and place the legs on top
of the worksurface. Position the legs on the worksurface per the following sections.
A - Humanscale Worksurface
B - Using Your Own Work-surface.
A - Humanscale Worksurface
Align the legs to the following pilot holes highlighted below. Note: Only the two rear pilot holes
are included for alignment. Worksurfaces come with different pilot hole options depending on the
size ordered.
Legend
eFloat Next Base
eFloat Next Hand Switch
Keyboard Tray
NeatTech Small for a 48"-54" wide worksurfaces
NeatTech Large for a 60"-72" wide worksurfaces
(30" Deep Worksurfaces only)
Not applicable with this table
21