Humanscale efloat next Assembly Instructions Manual page 36

B - Your Own Worksurface
If using your own top, locate the table frame using the measurements listed below. To create
pilot holes, mark hole locations carefully. Using a 3mm drill bit, drill a hole 10mm deep. Be careful
not to drill through your worksurface. Do not use tops larger than the size noted in the Important
Safety Instructions section.
A
B
Worksurface Depth
23"
24"
29"
30"
Worksurfaces between
23"- 30"
The 24" feet should be used for worksurfaces 23"-24" deep and the 30" feet should be used for
the worksurfaces 30" deep and less.
36
MAXIMUM DISTANCE 70"
FRONT
A
2"
B
Placeholder
Position frame by ensuring
the foot is centered
with the depth of the
worksurface.