Humanscale efloat next Assembly Instructions Manual page 38

9
Place your return worksurface upside down on a protective surface. Lift and place the return
frame on top of the worksurface. If using a shorter return worksurface the frame might over
hang the worksurface.
A - Humanscale Worksurface
B - Using Your Own Work-surface.
A - Humanscale Worksurface
If using a Humanscale Worksurface, align
the frame to the following pilot holes
highlighted below. Pilot holes are included
for the Left and Right Wing brackets.
FRONT
38
B - Your Own Worksurface
If using your own top, locate the table
frame using the measurements listed
below.
A
B
FRONT