Humanscale efloat next Assembly Instructions Manual page 37

7
Once the frame is adjusted to the width of the worksurface secure the width of the frame
using the (8) M6x 10 machine screws (7a). Tighten using the 4mm Allen Key (7b).
7a
7b
8
Using the (9) ST5 X 20 Wood Screws secure the frame to the worksurface. If using a power
drill ensure it is set to low torque. If using a Humanscale Worksurface please note only the
four outer pilot holes are included to assist in aligning your worksurface to table base.
37