Configuring Remote Dial-In - Compaq DS10L - AlphaServer - 256 MB RAM Reference Manual
Console reference
Hide thumbs
Also See for DS10L - AlphaServer - 256 MB RAM:
- Technical summary (16 pages) ,
- Installation instructions (3 pages)
Table of Contents
Advertisement
3.9
Configuring Remote Dial-In
Before you can dial in through the RMC modem port or enable
the system to call out in response to system alerts, you must
configure the RMC for remote dial-in.
Connect your serial terminal to the COM1 port and turn it on. Set up the RMC
parameters. Then disconnect the serial terminal, connect the modem, and
check your configuration.
Example 3–1 Dial-In Configuration
RMC> set password
RMC Password: ****
Verification: ****
RMC> set init
Init String: AT&F0E0V0X0S0=2
RMC> enable remote
Modem will be enabled when it is connected
RMC> status
.
.
Remote Access: Enabled
3-16
DS10 / DS10L Console Reference
- Quick Links:
- Powering up the System
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DS10L - AlphaServer - 256 MB RAM and is the answer not in the manual?
Questions and answers