Compaq DS10L - AlphaServer - 256 MB RAM Reference Manual page 129

NOTE: The following modems require the initialization strings shown here.
For other modems, see your modem documentation.
Modem
Motorola 3400 Lifestyle 28.8
AT &T Dataport 14.4/FAX
Hayes Smartmodem Optima 288
V-34/V.FC + FAX
Sets the password that is prompted for at the beginning of a modem
session. The string cannot exceed 14 characters and is not case sensitive.
For security, the password is not echoed on the screen. When prompted for
verification, type the password again.
Sets the initialization string. The string is limited to 31 characters and
can be modified depending on the type of modem used. Because the
modem commands disallow mixed cases, the RMC automatically converts
all alphabetic characters entered in the init string to uppercase.
The RMC automatically configures the modem's flow control according to
the setting of the SRM com1_flow environment variable. The RMC also
enables the modem carrier detect feature to monitor the modem
connectivity.
Enables remote access to the RMC modem port by configuring the modem
with the setting stored in the initialization string.
Because you have the serial terminal connected and not the modem, the
system responds that the modem will be enabled when it is connected.
Verify the settings and check that the Remote Access field is set to
Enabled, ready for the modem to be connected.
Disconnect the serial terminal, connect the modem and check that the
modem's TR light is lit. See Section 3.11 for dialing-in instructions.
Initialization String
AT&F0E0V0X0S0=2
AT&F0E0V0X0S0=2
AT&FE0V0X0S0=2
Remote Management Console 3-17