Enable Alert - Compaq DS10L - AlphaServer - 256 MB RAM Reference Manual

3.14.5

enable alert

The enable alert command enables the RMC to page a remote
system operator.
Before you can enter the enable alert command, you must configure remote dial-
in and call-out, set an RMC password (set password command), and enable
remote access (enable remote command) to the RMC modem port.
Syntax: enable alert
Example:
RMC> set dial
Dial String: atxdt9,15085553333
RMC> set alert
Alert String: ,,,,,,5085554444#;
RMC> enable alert
is connected
The system notifies you that when you connect the modem (after disconnecting
the serial terminal at the COM1 port), the alert will be enabled. Before you
connect the modem, you can issue the status command to see if the Alert
Enable field is set to Enabled.
If the enable alert command fails, the following error message is displayed:
*** ERROR - enable failed ***
.
3-30 DS10 / DS10L Console Reference
Modem will be enabled when it