Reset; Send Alert - Compaq DS10L - AlphaServer - 256 MB RAM Reference Manual

3.14.13 reset

The reset command is equivalent to pushing the Reset button on
the control panel.
The reset command restarts the system. The terminal exits RMC and
reconnects to the server's COM1 port. You must enter the entire word for the
command to take effect.
Syntax: reset
Example:
RMC> reset
Returning to COM port

3.14.14 send alert

The send alert command forces an alert condition.
This command is used to test the setup of the alert dial-out function, sending an
alert condition to the pager or the phone.
However, since your serial terminal is connected while you are entering the
command, initially the alert will not be able to be sent. When the RMC cannot
page the operator, it may be that the modem or terminal is in use. The RMC
waits approximately 30 minutes, and then resends the alert. This allows you to
connect the modem, and wait for the alert string.
If the pager does not receive the alert after a half an hour, re-check your setup.
Syntax: send alert
Example:
RMC> send alert
Alert detected!
3-36 DS10 / DS10L Console Reference