Table of Contents
Advertisement
Remote System Management
4.7.5 Configuring Remote Dial-In
Before you can dial in through the RMC modem port or enable the system to call out in
response to system alerts, you must configure RMC for remote dial-in.
Connect your modem to the 9-pin modem port and turn it on. Enter the RMC from either the
local serial terminal or the local VGA monitor to set up the parameters.
Example 4-1 Dial-In Configuration
RMC> set password
RMC Password: ****
Verification: ****
RMC> set init
Init String: AT&F0E0V0X0S0=2
RMC> enable remote
RMC> status
.
.
Remote Access: Enabled
.
.
.
______________________________ Note ___________________________
The following modems require the initialization strings shown here. For other
modems, see your modem documentation.
______________________________________________________________
Modem
Motorola 3400 Lifestyle 28.8
AT &T Dataport 14.4/FAX
Hayes Smartmodem Optima 288
V-34/V.FC + FAX
c
Sets the password that is prompted for at the beginning of a modem session. The string cannot
exceed 14 characters and is not case sensitive. For security, the password is not echoed on the
screen. When prompted for verification, type the password again.
š
Sets the initialization string. The string is limited to 31 characters and can be modified
depending on the type of modem used. Because the modem commands disallow mixed cases,
the RMC automatically converts all alphabetic characters entered in the init string to
uppercase.
The RMC automatically configures the modem's flow control according to the setting of the
SRM com1_flow environment variable. The RMC also enables the modem carrier detect
feature to monitor the modem connectivity.
›
Enables remote access to the RMC modem port by configuring the modem with the setting
stored in the initialization string.
œ
Verifies the settings. Check that the Remote Access field is set to Enabled.
4–12 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
™
š
›
œ
Initialization String
AT&F0E0V0X0S0=2
AT&F0E0V0X0S0=2
AT&FE0V0X0S0=2
Advertisement
Table of Contents
Troubleshooting
