Enable Remote - Compaq DS10L - AlphaServer - 256 MB RAM Reference Manual

3.14.6

enable remote

The enable remote command enables remote access to the RMC
modem port by configuring the modem with the setting stored in
the initialization string.
This command also allows the RMC to automatically dial the phone number set
with the set dial command upon detection of alert conditions.
Before you can enter the enable remote command, you must configure remote
dial-in by setting an RMC password (set password command) and initializa-
tion string. The enable remote command remains in effect until you enter the
disable remote command.
Syntax: enable remote
Example:
RMC> set password
RMC Password: ****
Verification: ****
RMC> set init
Init String: AT&F0E0V0X0S0=2
RMC> enable remote
The system notifies you that when you connect the modem (after disconnecting
the serial terminal at the COM1 port), remote access will be enabled. Before you
connect the modem, you can issue the status command to see if the Remote
Access field is set to Enabled.
If the enable remote command fails, the following error message is displayed:
*** ERROR - enable failed ***
Modem will be enabled when it
is connected
Remote Management Console 3-31