Set Com1_Mode - Compaq DS10L - AlphaServer - 256 MB RAM Reference Manual

3.14.16

set com1_mode

The set com1_mode command specifies the COM1 data flow
paths, so that data either passes through the RMC or bypasses it.
See Section 3.3 for descriptions of the RMC modes.
Syntax: set com1_mode value
where value can be:
snoop Data partially bypasses the RMC, but the RMC taps into
the data lines and listens passively for the RMC escape
sequence.
Data bypasses RMC, but the RMC switches automatically
soft_bypass
into snoop mode if an alert condition or loss of carrier
occurs.
Data bypasses the RMC. The RMC is
Firm_bypass
effectively disabled.
Example:
>>> set com1_mode
COM1_MODE (SNOOP, SOFT_BYPASS,
FIRM_BYPASS)
3-38 DS10 / DS10L Console Reference