Draytek Vigor C410 Series User Manual page 114

Available settings are explained as follows:
Item
Enabled
Local AS
Router ID
Connected
Static
RIP
OSPF
Connected
Static
RIP
OSPF
Cancel
Apply
II-1-8-2 IPv4 Neighbors
Set general settings for the neighboring routers (based on IPv4 address).
Description
Switch the toggle to enable/disable the basic BGP function for local
router.
Set the AS number for local router.
Specify the LAN subnet for the router.
IPv4 Redistribute
All Networks – Apply the BGP profile to all the LAN interfaces.
Exclude NAT Networks - Apply the BGP profile to all the LAN
interfaces except for NAT network.
Switch the toggle to enable or disable the function (apply the static
route to the BGP profile).
Switch the toggle to enable or disable the function (apply the RIP
function to the BGP profile).
Switch the toggle to enable or disable the function (apply the OSPF
function to the BGP profile).
IPv6 Redistribute
Switch the toggle to enable (apply the BGP profile to all the LAN
interfaces) or disable the function.
Switch the toggle to enable or disable the function (apply the static
route to the BGP profile).
Switch the toggle to enable or disable the function (allow dynamically
route traffic based on information learned from the RIP protocol).
Switch the toggle to enable or disable the function (allow dynamically
route traffic based on information learned from the OSPF protocol).
Discard current settings and return to the previous page.
Save the current settings and exit the page.
104