Lightware MMX2-4x3-H20 User Manual page 106

    7. LW3 Programmers' Reference
7.8.8. Resetting the Emulated EDIDs
Command and Response
ç CALL·/V1/EDID:reset()
æ mO·/V1/EDID:reset
Parameters
Parameter Parameter description
<user_edid> The emulated EDID memory of the desired input port.
Example
ç CALL /V1/EDID:reset()
æ mO /V1/EDID:reset
Calling this method switches all emulated EDIDs to a factory default one. See the table in the
List
section.
MMX2 series – User's Manual
7.9. Ethernet Port Configuration
7.9.1. Setting the DHCP State
Command and Response
Values Value description
U1-U14 User EDIDs
Parameters
Factory EDID
Example
7.9.2. Changing the IP Address (Static)
Command and Response
Example
Applied firmware package: v2.9.0b6 | LDC software: v2.7.6b4

When you change a network property, the new value is stored, but the applySettings method
ATTENTION!
must always be called to apply the new settings. When two or more network parameters are changed, the
applySettings method is enough to be called once as a final step; it will reboot the device.
#dhcp #network #ipaddress
SET·/V1/MANAGEMENT/NETWORK.DhcpEnabled=<dhcp_status>
ç
æ
pw·/V1/MANAGEMENT/NETWORK.DhcpEnabled=<dhcp_status>
If the <dhcp_status> parameter is true, the current IP address setting is DHCP, if the parameter is false, the
current IP address is static.
ç SET /V1/MANAGEMENT/NETWORK.DhcpEnabled=true
æ pw /V1/MANAGEMENT/NETWORK.DhcpEnabled=true
ç CALL /V1/MANAGEMENT/NETWORK:applySettings()
æ mO /V1/MANAGEMENT/NETWORK:applySettings


INFO: The applySettings method will save and apply the new value, and will reboot the device.


INFO: The current setting can be queried by using the
SET·/V1/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
ç
æ pw·/V1/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
ç SET /V1/MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.85
æ pw /V1/MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.85
ç CALL /V1/MANAGEMENT/NETWORK:applySettings()
æ mO /V1/MANAGEMENT/NETWORK:applySettings


INFO: The applySettings method will save and apply the new value, and will reboot the device.


INFO: The current setting can be queried by using the
106
GET command.
GET command.