View Menu; Sensor Menu - Pepperl+Fuchs SmartRunner Manual

SmartRunner Detector
Vision Configurator Software
5.3.2

View Menu

Figure 5.4
Show standard buttons
Show device data
Displayed message
types...
Table 5.3
5.3.3

Sensor Menu

Figure 5.5
Load settings
Save settings
Change network settings Change the network settings. The settings window allows you to
Make firmware update
Show device version
Sync with sensor
Adjust sensor calibra-
tion
Table 5.4
Note
Firmware Update
Once you have upgraded the firmware and Update complete is displayed, restart the sensor.
View Menu
Toggles the display of the buttons in the bar on the left on and off.
Hides the display of the sensor data in the top right of the screen.
Opens a selection window in which the following display windows
can be activated or deactivated: Info, Result OK, Result not OK,
Warning, Error, Critical, Assert.
View menu
Sensor menu
Loads the saved settings from the sensor
Saves the settings to the sensor
set the IP address, subnet mask, gateway address, and DHCP
Performs firmware updates. This command should be used by
experienced users only
Displays the device version
Synchronization with the sensor
Adjust the sensor calibration
Sensor menu
27