Removing A Device From The Versabay Ii - NEC VERSA 6000 Manual

Removing a Device from the VersaBay II

Use the following steps to remove the standard diskette drive (or other de-
vice) from the VersaBay II, and replace it with the 6x CD-ROM reader that
ships with the system.
NOTE
fied as a slave device in the Setup utility. Also, check that the switch
on the back of the reader is set to the right (positioned next to the S
for Slave).
If you install a hard disk drive from a Versa model E, V, M, or P in
the VersaBay II, it becomes the master drive from which the system
boots.
Make sure the NEC Versa 6000 is powered off, all options are discon-
1.
nected, and the LCD panel is closed.
Turn the system upside down with the front facing you.
2.
Locate the VersaBay II release latches on the bottom of the unit.
3.
A CD-ROM reader installed in the VersaBay II must be speci-
VersaBay II release latches
Using Your NEC Versa 6000 4-7