Table of Contents
Advertisement
References to the drive letter listed under My Computer and the Windows Explorer
change automatically when the device is swapped or removed. The balloon message
that appears when you move your cursor over the taskbar icon also changes to reflect
the new VersaBay status.
Removing a Device from the NEC VersaBay III
Use the following steps to remove a device from the NEC VersaBay III.
Your system must be in a sleep state or powered off before removing or inserting
devices in the NEC VersaBay III.
1.
Use the NEC VersaBay III Swap Utility to put your system into a sleep state or
power off the system.
Close the LCD panel and turn the system upside down.
2.
Locate the NEC VersaBay III release lock and release latch on the bottom of the
3.
unit.
A – NEC VersaBay III Release Lock
4.
Slide the lock to the unlocked position before releasing the latch.
Slide the latch toward the battery bay and hold it.
5.
Pull the device out of the system.
6.
5-6 Using the System Drives and Bays
NEC VersaBay III release lock and latch
B – NEC VersaBay III Release Latch
Advertisement
Table of Contents
