NEC VERSA 6000 Manual page 121

MESSAGE
Non-system disk or
disk error; Replace
and press any key
when ready
Operating System Not
Found
or
Fixed Disk Failure 0
Invalid configuration
information – run Setup
program
Real time clock
failure
Time-of-day not set –
run Setup
System CMOS
Checksum Bad – run
Setup
or
Press (F1) to resume,
(F2) to setup.
Fixed disk configuration
error
Fixed disk failure
Fixed disk controller
failure
7-4 Solving Problems
POST Error Messages
WHAT TO DO
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable disk in drive A and press
any key.
Press to start Setup. Change the hard disk type to
F2
the correct setting. Exit and save Setup changes.
One or more system configuration parameters
are not properly set. Start Setup, set them correctly,
and exit and save to update the parameters.
Set time and date using Setup. Exit and save to
update the parameters.
Set the time and date using Setup. Exit and save
Setup changes to update the parameters.
Press F2 to enter Setup. Under Exit, set the default
values. Under Main, set the date and time. Save
your changes and exit.
Start Setup. Exit and save to update the parameters.
Check to see if the hard disk connector is seated
properly. If there is still a problem, the hard disk
might need repair.
Press F2 to start Setup. Exit and save to update the
parameters.
Check to see if the hard disk connector is seated
properly.
If there is still a problem, the hard disk might need
repair.
Press F2 to start Setup. Exit and save to update the
parameters.
Check to see if the hard disk connector is seated
properly.