Start-Up Problems - NEC VERSA 6000 Manual

PROBLEM
LCD screen is dark
and blank.
Battery power does not
last long.
Information on the LCD
screen is difficult to see.
An optional component
does not work.
The Suspend/Resume
button does not work.

START-UP PROBLEMS

The system displays an invalid configuration error message at power on
when there are the following conditions:
the current configuration information doesn't match configuration infor-
mation stored in Auto Setup, such as when an internal option is added.
the system loses configuration information.
If either condition is true, the system displays an "invalid configuration in-
formation" message.
7-2 Solving Problems
Troubleshooting
WHAT TO DO
Power-saving mode has shut off the backlight.
Press a keyboard key or the Suspend button.
The built-in LCD may not be selected. Press
Fn F3 once or twice.
Brightness control needs adjustment. Adjust the
control.
The system entered Suspend mode due to low
battery power. (Check the Status bar for a half-
moon icon.) Plug in the AC adapter or replace
the battery pack, then press the Suspend button to
resume operation.
Use power-saving modes.
Adjust the brightness control.
Make sure the component is securely installed or
connected. Verify that the system parameter for the
I/O port configuration is set correctly in Setup.
A disk drive might be busy. Wait until the disk drive
stops and try again.
The NEC Versa may be connected to a docking
station. Some power management functions do
not work when the NEC Versa is docked.